SAW CHAIN LUBRICATION SYSTEM
25
DCS-1600
4-2 Inspecting oil line
1. Remove oil line (K) from oil line (G).
NOTE:
Be careful not to enter oil line (G) into mo-
tor cover. Otherwise, it’s difficult to reconnect oil
line (G) and oil line (K).
2. Connect oil line (G) to pressure tester 897803-
30133 (T).
3. Remove fuel cap and pull out oil strainer from oil
tank.
4. Pinch oil line (G) with longnose pliers as shown.
NOTE:
Wrap the ends of longnose pliers with
tape(or cover with soft pipes) to protect oil line
from damage.
5. Apply pressure approx. 49 kPa (0.5 kgf/cm
2
)
(7psi).
6. If pressure drops, replace oil line (G) with new
one. (Refer to Section 4-5)
T
G
K
G