Echo CPH-58V, Руководство оператора

Страница: 9 / 30

English 7
ASSEMBLY

Align the hole in the attachment shaft with the retaining
pin on the power head shaft and slide the two shafts
together.

Rotate the retaining pin 1/4 turn to allow the pin to fully
seat through the hole in the attachment shaft.
NOTE: If the pin does not release completely in the posi-
tioning hole, the shafts are not locked into place. Slightly
rotate from side to side until the pin is locked into place.

Tighten the knob securely.
WARNING
Be certain the knob is fully tightened before operating
equipment; check it periodically for tightness during use
to avoid serious personal injury.
Removing the Attachment From the Power
Head
See Figure 2.

Stop the motor and remove the battery pack.

Loosen the knob.

Pull the retaining pin and twist the shafts to remove and
separate ends.
Attaching the Front Handle
See Figure 3.

Remove the bolts, flat washers, and lock washers from
the front handle.
 Install the handle on the power head shaft in the area
indicated by the illustration.

Adjust handle up or down, if necessary, to desired
operating position.
 Reinstall the washers and bolts; tighten securely.
Installing an Attachment to the Power Head
See Figure 2.
WARNING
Read and understand entire Operator’s Manual for
each optional attachment used on this power head and
follow all warnings and instructions. Failure to follow
all instructions could result in electric shock, fire and/
or serious personal injury.
WARNING
This 58 V power head is designed to be used only
with the attachment models that are specified in this
Operator’s Manual. It is not designed to be used with
brush cutters or other attachment models. Use of other
attachments could cause serious personal injuries or
property damage.
WARNING
Never install, remove, or adjust any attachment while
power head is running. Failure to stop the motor can
cause serious personal injury. Never operate power head
without an attachment.
This 58 V power head may be used with only the following
ECHO attachment:

SSA-58V Straight Shaft String Trimmer
The attachment connects to the power head by means of
a coupler device.

Stop the motor and remove the battery pack.

Loosen the knob on the coupler of the power head shaft
and remove the end cap from the attachment.

Pull the retaining pin located on the power head shaft and
rotate 1/4 turn. Rotating allows the pin to lock out of the
shaft even when released.