© 1990-2023 - All Rights Reserved - ECdesigns
https://www.ecdesigns.nl
/
9 19
Jumper settings
Disconnect the mains power cable from the PowerDAC-SX !
In order to access the jumpers, remove the PowerDAC-SX TOP cover by removing 8 x 2mm hex bolts.
Carefully remove or place jumpers using tweezers.
WARNING! Make sure to re-install the jumper on the far right after programming !
When replacing the top cover, make sure rear and front panels lock into the top cover slots correctly before
tightening the 8 hex bolts.
