© 1990-2023 - All Rights Reserved - ECdesigns
https://www.ecdesigns.nl
/
11 19
Screenshots here from
STM32CubeProgrammer
On the right hand side of the screen you should see:
Port: USB1, if not then try the refresh button on the right
side of the Port dropdown button.
If not working check jumper settings and USB cable
connection.
Now press the
Connect
button.
Then use the
Open file
button to load the firmware file.
Click the Download button to load firmware file in the
PowerDAC-SX.
After message: File download complete
Press the OK button on message window.
Finally click on the Disconnect button to finish session.
You can then close the STM32CubeProgrammer.
Remove the USB cable between PowerDAC-SX and PC.
Set jumpers to the normal positions.
After power-up PowerDAC-SX the new firmware is used.
