Chengdu Ebyte Electronic Technology Co.,Ltd.
E610-433TxxS User Manual
Copyright ©2012–2023
，
Chengdu Ebyte Electronic Technology Co.,Ltd.
14
When AUX=0 the buffer is not empty: the data in the internal 4096 byte buffer, has not all been written to the wireless
chip and turned on transmitting, at this time the module may be waiting for the user data to end the timeout, or is in the
process of wirelessly splitting the packet to transmit.
In continuous transmission mode.
The data in the buffer is "store-and-fetch", so the buffer size can be considered infinite.
[Note]: When AUX=1, it does not mean that the module has finished transmitting all the serial data over the wireless port,
it may be that the last packet of data is being transmitted.
Timing diagram of the AUX pins when the module receives data from the serial port
5.6.3 Modules are in the process of being configured
presents the following states only during power-on reset, command reset and when exiting sleep mode (mode 3).
Timing diagram of the AUX pins during module self-test
5.6.4 Module power-up initialisation process
'T1' in the diagram: represents the initialization of the microcontroller peripherals (initialization time of 4~5ms).
'T2' in the diagram: represents the initialization of the RF chip configuration parameters (initialization time of about
500ms).
AUX pin in the microcontroller initialization, due to the configuration of GPIO peripherals will lead to the pin will be a
momentary pull low, as shown in the following figure.
