Chengdu Ebyte Electronic Technology Co.,Ltd.
E610-433TxxS User Manual
Copyright ©2012–2023
，
Chengdu Ebyte Electronic Technology Co.,Ltd.
13
5.3 Broadcast address
Example: Set the address of module A to 0xFFFF and the channel to 0x04.
When module A is used as transmitter (same mode, transparent transmission method), all receiving modules under 0x04
channel can receive data for broadcasting purpose.
5.4 Listening Address
Example: Set the address of module A to 0xFFFF and the channel to 0x04.
When module A is used as receive, it can receive all data under 0x04 channel for the purpose of listening.
5.5 Module reset
When the module is powered up, the AUX will immediately output low and carry out a hardware self-test as well as
setting the operating mode according to the user parameters.
During this process, the AUX remains low and when finished the AUX outputs high and starts working normally
according to the working mode formed by the combination of M1 and M0;.
Therefore, the user needs to wait for the rising edge of AUX as the starting point for the normal operation of the module.
5.6 AUX Explained
AUX is used for wireless transceiver buffer indication and self-test indication.
indicates whether the module has data that has not yet been transmitted over the wireless, or whether the wireless data
that has been received has not all been sent out over the serial port, or whether the module is in the process of initializing
for self-test.
5.6.1 Serial data output indication
for waking up an external MCU in hibernation
.
Timing diagram of the AUX pins when sending data out of the module's serial port
5.6.2 Wireless transmission indication
In general transmission mode.
Buffer empty: data from the internal 4096 byte buffer, all written to the wireless chip (automatic packet splitting).
continuous user initiated data of less than 4096 bytes when AUX=1, without overflow.
