ADJUSTING REAR BRAKE TOE PEG
The rear brake toe peg can be adjusted for rider preference.
1.
See Figure 13. Loosen the fastener from the toe peg.
2.
Slide toe peg to the desired position.
3.
Tighten the fastener to 48-72 in-lbs (5.4-8.1 Nm).
NOTE
To adjust the rear brake master cylinder pushrod, see an EBR
Dealer
ADJUSTING FRONT BRAKE LEVER
The front brake hand lever may be adjusted to the rider's
preference.
See Figure 14. Turn knob to desired position.
NOTE
It is easier to adjust the dial if you gently push the lever
outward to reduce pressure on the adjuster.
After adjusting hand lever position, rotate steering to full left
and full right positions to make certain the levers do not
contact the fairing.
^
WARNING
Do not position fingers between hand control lever and
handlebar grip. Improper hand positioning can impair control
lever operation and cause loss of vehicle control, which could
result in death or serious injury.
FUEL FILLER CAP
^
WARNING
Avoid spills. Slowly remove filler cap. Do not fill above bottom
of fill plate, leaving air space for fuel expansion. Secure filler
cap after refueling. Gasoline is extremely flammable and
highly explosive, which could result in death or serious injury.
^
WARNING
Use care when refueling. Pressurized air in fuel tank can force
gasoline to escape through filler tube. Gasoline is extremely
53
Содержание 1190 SX
