The motorcycle will have a reduced RPM range until the
engine is warmed up. If you read this section and still have
questions about the correct operation of your motorcycle, talk
to an authorized EBR dealer for assistance.
STOPPING THE ENGINE
Turn engine OFF/RUN switch to OFF. See figure 22.
SHIFTING GEARS
Getting Started
CAUTION
The clutch must be fully disengaged before attempting a gear
shift. Failure to fully disengage the clutch can result in
equipment damage.
NOTE
Always start engine with transmission in neutral. Always start
motorcycle’s forward motion from first gear.
1.
With motorcycle engine running and sidestand
retracted, pull the clutch hand lever in against handlebar grip
to fully disengage the clutch.
2.
Push the foot shift lever down to the end of its travel
and release it. The transmission is now in first gear.
3.
To start forward motion, release the clutch lever
slowly to engage the clutch and at the same time, gradually
open the throttle in one smooth motion.
Figure 23
65
Содержание 1190 SX
