25/37
Item no.: HAB 100177146 - 000 · EN · Change· Release 2020-10-26
Control electronics
Control electronics
VTD-60.XX-K5SB
VTD-60.XX-K5SB
Installation
5.4 Connecting control electronics to electricity source
5.4.1 Connector systems
NOTICE
In order to operate the motor with nominal current, the cross-sections of the connecting cables must be
configured to the respective operating current in accordance with applicable national standards.
The maximum possible cross-sections of the connectors must be used for the nominal values of the device. A
minimum cable length of 20 cm must be adhered to.
NOTICE
Make sure that the cores are correctly clamped to the stripped part of the conductor and not to the insulation.
Further information can be found at
Connection of the tension spring terminals Weidmueller BLZF 3.5
(installed in VTD-60.13-K5SB – interface X1)
The drive controllers use connectors with tension spring technology for single/fine wire conductors.
The following overview shows which conductor cross-sections can be used with the connector:
Terminal Designation/item no.
Terminal area (cross-section d) mm
2
Stripping
length mm
Single-wire
H05(07)V-U
Fine-wire
H05(07)V-K
Fine-wire
with wire-end
ferrule
Fine wire with
wire-end
ferrule and
plastic collar
X1
BLZF 3.5/180/6 1690460000
0.2 to 1.5
0.2 to 1.5
0.2 to 1.5
0.2 to 1
10
Screwdriver
Insulation
Single/fine-wire conductor
Conductor with wire-end ferrule
d = core cross-section
A = stripping length
Insulation
d
A
