Q3
PL
29
www.eberg.eu
heat gear, the device will switch to heating in the second heat
gear, but without the set temperature.
4. When the device is working in the set temperature mode,
pressing the button „
„ will disable set temperature mode.
Canceling the
weekly timer
1. Pressing the button „
„ while the setting the weekly timer
mode will cancel settings and exit this mode.
2. When the unit is already working in the weekly timer mode,
first press the button „
„ then pressthe button „
„ to
cancel settings.
3.1 In the set temperature mode, when you cancel the weekly
timer mode, the unit will enter the heating mode in the second
heat gear.
3.2 In heating mode in the first gear, when the weekly timer
settings are canceled, the device will switch to heating in the first
gear.
In heating mode in the second gear, when the weekly timer
settings are canceled, the device will switch to heating in the
second gear.
Overheating
The maximum detection temperature is 51°C, the device turns off
when the detected temperature reaches 51°C.
6. USE AND REPLACEMENT OF THE REMOTE CONTROL BATTERY
1.
Before using the remote control for the first time, remove the plastic insulation foil from the battery.
Pull it out in the direction shown by the arrows in figure 1.
2.
If the battery in the remote control requires replacement, to remove it you need to:
• release the lock - the direction is shown by arrow 2 in figure 2,
• then pull out the drawer with the battery - the direction is shown by the arrow 3 in
• figure 2,
• replace the battery,
• after replacing the battery, insert the drawer with the new battery into the remote control until
the lock engages.
3.
A lithium battery CR2025 is used in the remote control.
Fig. 1
Fig. 2
