AQUMI
46
47
Notice
If the unit put on the un-level ground or not correctly install the drain pipe, the water will full the bucket
and stop run. If that happened, please check the ground is whether horizon, and the drain pipe is
correctly installed. At the same time, the bucket need to be install correctly.
Before cleaning or maintenance, turn the appliance off by pressing the “POWER” buttonon the control
panel, wait for a few minutes then unplug from the mains socket.
Automatic defrost
When frost builds up on the evaporator coils, the compressor will stop and the fan will continue to run
until the frost disappears. When the coils are completely defrosted, the compressor will automatically
restart and dehumidify will resume.
Cleaning the cabinet
You should clean the appliance with a slightly damp cloth then dry with a dry cloth.
•
Never wash the appliance with water, it could be dangerous.
•
Never use petrol, alcohol or solvents to clean the appliance.
•
Never spray insecticide liquids or similar.
Location requirements
The unit operating in a basement will have little no effect in drying out an adjacent enclosed storage
area, such as a closet, unless there is adequate circulation of air in and out of the area.
1.
Do not use outdoors.
2.
This appliance is intended for indoor use only. Place the appliance on a smooth, level floor surface
that is strong enough to support the unit with a full bucket of water.
3.
Allow at least 18” (45cm) of around and above space away from the wall for efficient working.
4.
Place the appliance in an area where the temperature will not fall 5°C(41°F).
5.
Use the dehumidifier in cooking, laundry, bathing and dishwashing areas that have excessive
moisture.
6.
Place the dehumidifier away from a clothes dryer.
7.
Use the dehumidifier in a basement to help prevent moisture damage.
8.
The dehumidifier must be operated in an enclosed area to be most effective ,close all doors,
windows and other outside openings to the room.
9.
Do not block the air inlet or outlet of the appliance. Reduced air flow will result in poor performance
and could damage the unit.
5. CLEANING AND MAINTAINENECE
Cleaning the filter
•
To keep your appliance working efficiently you should clean the filter
every week of operation.
•
The filter can take out like fig.
•
To avoid possible cuts, avoid contacting the metal parts of the
appliance when removing or re-installing the filter. It can result in the
risk of personal injury.
•
Use a vacuum cleaner to remove dust accumulations from the filter.
If it is very dirty, immerse in warm water and rinse a number of times.
The water should never be hotter than 40°C(104°F). After washing,
leave the filter to dry then attach the intake grille to the appliance.
