EAW UXA4410 series, Руководство пользователя

Страница: 29 / 45

Tel 800 992 5013 / +1 508 234 6158
|
www.eaw.com
29
Line Array
Application Guide
The Greybox is now loaded, as shown below in the Edit Window. NOTE: The output channels
should be color coded to match the assigned input channel (i.e. orange in this example).
Unify Processor Interfaces
CRITICAL SETUP NOTE:
It is necessary to “teach” each amplifier which Dante card is installed internally. If more
than one Processor and Dante Interface is seen in the list, it is suggested to turn off
all amplifiers except one. Refresh the network, then Unify the processor to the Dante
card. Repeat this for each amplifier. This will ensure that you are connecting the correct
Amplifier Processor to the Correct Dante Card in that amplifier.
This will not be necessary in a future firmware build, but for now it is highly suggest
doing this step to ensure network control stability.
This function is to assist in determining the network address of the primary and secondary
Dante card when Resolution is connected to the Ethernet port of a UX processor or UXA
amplifier. The IP address of the Dante card is stored in the internal memory. This is only required
once unless the internal Dante card is replaced.