11
Detent models are indicated by the letter ‘N’ stamped into
the unit nameplate. Figure 7 illustrates the spool/spring
arrangement on detent models.
Figure 7. Detented ‘‘N’’ Model
Solenoid ‘‘A’’ is energized and shifts pilot spool to the right.
Which causes main stage spool to shift left. Oil flow from
P
³
A and B
³
T is obtained.
Main stage spool remains in position attained due to pilot
valve detent until solenoid ‘‘B’’ is energized. (Note: If pilot
pressure fails, the main stage will shift to center position.
1.
2.
3.
Detent
Main
Stage
A
B
P
T
T
Pilot
Solenoid
A
B
P
B
A
E. Optional Features (Main Stage)
Control of the mainstage spool travel can be modified with
certain optional features. The most common features are
discussed in the following paragraphs.
1. Stroke Limiter Adjustment (Fig. 8): Main stage spool
travel can be limited by using stroke adjust covers. Stroke
adjust covers may be used on one or both ends of the main
stage section. When the stroke is limited, maximum flow
through the valve is reduced (assuming same inlet pressure).
This slows the actuator movement.To limit the spool travel,
loosen the jam nut and turn adjusting screw clockwise.
Figure 8. Stroke Adjuster Feature
2
7
5
1
3
4
6
Main
Stage
Spool
Part No.
Part Name
1
2
3
4
Cover
Spring
O-Ring
Back-up Ring
Part No.
Part Name
5
6
7
Piston
Jamnut
Adjuster Screw
2. Pilot Choke Option (Fig. 9): A pilot choke increases the
amount of time it takes to shift the main stage spool from
one position to another. Increasing shift time lowers the
possibility of developing large flow transients in the circuit. A
pilot choke is designed to allow free flow to one end of the
main stage spool but restricts flow out of the opposite end.
The rate of spool travel, in either direction, can be slowed by
loosening a locknut and turning an adjusting screw
clockwise. To increase the rate of spool travel, turn the
adjusting screws counterclockwise. When a pilot choke is
used, pilot pressure should be taken from a constant
pressure source. The pilot choke is mounted between the
pilot valve and the main stage sections.
Figure 9. Pilot Choke
7
9
5
1
6
12
13
4
14
2
3
8
11
10
Part No.
Part Name
1
2
3
4
5
6
7
Retaining Ring
Nut
Adjusting Screw
‘‘O’’ Ring
Back-up Ring
Needle Housing
‘‘O’’ Ring
Part No.
Part Name
8
9
10
11
12
13
14
Back-up Ring
Needle
Spring
Sleeve
Body
Dowel Pin
‘‘O’’ Ring
