Eaton RTX-12510, Руководство по обслуживанию

Страница: 41 / 126

C .
Removal of the Countershaft Bearings
1. Remove the snap ring from the rear of each counter-
shaft.
2. From inside the case, use a mall and punch to drive the
countershaft rear bearings to the rear and from the case
bores and shafts.
NOTE: Removal procedures will most likely damage the
bearings and removal should not be attempted unless
replacement of the bearings is planned.
3. Cut the lockwires, turn out the lockscrews and remove
the two front bearing retaining plates.
4. Use a soft bar and mall to drive each countershaft as far
to the rear as possible. This will partially unseat the front
bearings.
5. Use a soft bar and mall on the rear of each countershaft
to drive each shaft as far forward as possible, unseating
the front bearings from the case bores. This will expose
the front bearing snap rings.
6. Use a bearing puller to remove the countershaft front
bearings.
41