Eaton Power Xpert 9395P-600/600, Инструкция по установке и эксплуатации, Страница: 87 / 226

Eaton ® Power Xpert ® 9395P-600 (300V-600V) Installation and Operation Manual 164000710—Rev 07 69
44..33 M Meecchhaanniiccaallllyy JJooiinniinngg tthhee S Seeccttiioonnss ((660000V V M Mooddeellss O Onnllyy))
NOTE The following procedure permits the UPS sections to be installed in a location where
there is limited space to slide the sections together from the sides.
NOTE For the following steps, verify that the forklift or pallet jack is rated to handle the weight
of the section (see
Table 2 for cabinet weight).
1. Using a forklift, move the UPM section to the final installed location.
2. Remove one top screw and two bottom screws securing the UPM section wireway panel (see Figure 21 ).
Lift the panel straight up to remove it from the panel hanger brackets at the top of the cabinet.
3. Remove the screws securing the top and bottom internal safety shield panels and remove the panels.
Retain the hardware for later use.
4. Remove the screws securing the corner channel and remove the channel (see Figure 21 ). Retain the
hardware for later use.
Figure 21. Section Joining
Left Top Panel
Wireway Panel
Left Middle Panel
Corner Channel
UPM Section
Interior Left Side Panel
Installation