Eaton EVT-300, Инструкции для водителя

Страница: 18 / 34

15
Driver ID Card (Optional)
Driver Identification Card
If the system configuration requires a Driver Identification Card, (see Figure
10), it must be inserted into the slot provided on the front of the Driver Display
Unit (see Figure 8, page 13). After the system is powered on, insert the card
into the slot with a smooth steady continuous motion. Allow approximately
one (1) second to ensure the reading of the bar code. A high-pitched confir-
mation tone will sound when the card is correctly scanned. The card should be
removed and stored is a safe place until required again. If the bar code is not
scanned correctly, one low-pitched tone will be heard.
If the card is not installed into the slot in the Driver Display Unit, when
required, two events can occur, the green “ON” light will flash continuously or
the green “ON” light will flash continuously accompanied by a matching audi-
ble tone. This is a configurable option.
Driver Identification Card (Optional)
Figure 10