Eaton EVT-300, Инструкции для водителя

Страница: 19 / 34

16
Initial Start-Up
EVT-300 Start-Up
WARNING: Be sure the vehicle is not moving during the initial
self-test at vehicle’s start-up. Otherwise, the system may not
operate properly. No Collision Warning System alerts will be
given by the EVT-300 until all lights are extinguished after the
self-test is complete.
1. The EVT-300 system powers up when turning the vehicle ignition key
to the run position. All Driver Display Unit and Side Sensor indicator
lights will illuminate and stay on until the self-test is complete.
2. If the green “ON” indicator is flashing, insert the Driver Identification
Card (see page 15) into the Driver Display Unit so the system can
identify the driver of the vehicle.
3. If the green “S/C” (SmartCruise) light flashes eight (8) times after the
self-test is completed, an Accident Reconstruction event has been
stored in memory. The light will continue to flash 8 times during
every start-up until the event is cleared. Notify management to assist
you with this procedure. If the event has been stored mistakenly, the
system software should clear the system in 30 days.
4. If the “FAIL” indicator light (or headway control failure) comes on
and stays on after the self-test or while driving, a component or sys-
tem failure has occurred. This may render the VORAD system inop-
erable. If the SmartCruise option is enabled and a failure occurs,
SmartCruise will no longer function (see page 25) until the fault has
been corrected and the ignition switch has been turned OFF and then
back ON. Collision Warning lights and tones may still work correctly
when SmartCruise failures occur that are brought on by a compo-
nent or system failure.