Eaton EU5C-SWD-EIP-MODTCP, Руководство пользователя

Страница: 20 / 113

2 Installation
2.1 Setting the gateway's field bus address
16
SmartWire-DT Gateway EU5C-SWD-EIP-MODTCP 08/17 MN120003Z EN www.eaton.eu
To activate the PGM operating mode, set DIP switches 3 and 9 to "ON".
Set DIP switches 1, 2, and 4 to OFF.
Address setting PGM-DHCP
In this case, an address is assigned once, via a DHCP server on the field bus,
when the gateway is put into operation for the first time.
The addresses assigned by the DHCP server for the gateway's IP address,
the subnet mask, and the default gateway address will be stored in the gate-
way's non-volatile memory. In addition, the gateway will use a flag bit to
"remember" the fact that these addresses have already been assigned. Every
time the gateway is turned on after this, it will first check the flag bit. If the
flag bit is set, the gateway will obtain its addresses from its non-volatile
memory. In other words, it will behave the same way as with the PGM oper-
ating mode.
SWD-Assist can be used to read and edit address information, as well as to
store it in the gateway's non-volatile memory.
If you want to reset the gateway in the PGM-DHPC operating mode, you will
have to reset the flag bit. To do this, select a different operating mode while
the gateway is off and then start the gateway. If the gateway detects an
operating mode other than DHCP-PGM when it is turned on, it will reset its
flag bit. If you then select the DHCP-PGM operating mode, the gateway will
request new addresses from the DHCP server just like when it is first put
into operation.
To activate the DHCP-PGM operating mode, set dip switches 4 and 9 to
"ON".
The dip switches 1, 2, 3 are set to „OFF“.
DIP Switch
1 2 3 4 5 6 7 8 9 0 Description
2
0
2
1
2
2
2
3
2
4
2
5
2
6
2
7
MODE
OFF OFF ON OFF X X X X ON X PGM: Setting of the
IP address with SWD
assist
1) X means that the position of the corresponding dip switch will be ignored.
DIP Switch
1 2 3 4 5 6 7 8 9 0 Description
2
0
2
1
2
2
2
3
2
4
2
5
2
6
2
7
MODE
OFF OFF OFF ON X X X X ON X PGM-DHCP: IP address
received once via DHCP
1) X means that the position of the corresponding dip switch will be ignored.