Eaton EU5C-SWD-EIP-MODTCP, Руководство пользователя

Страница: 15 / 113

1 SmartWire-DT Gateway EU5C-SWD-EIP-MODTCP
1.4 Important data for engineering
SmartWire-DT Gateway EU5C-SWD-EIP-MODTCP 08/17 MN120003Z EN www.eaton.com
11
1.4 Important data for engineering
In connection with the SmartWire-DT modules, the gateway appears as a
modular module on the relevant field bus. The following gateway can be run
on the field buses specified below:
Each SmartWire-DT module is presented as a separate module, with its data,
to the field bus master.
The following number of SmartWire-DT modules is the maximum number
that can be run on the gateway:
Make sure to take the maximum volume of data that can be transmitted on
the field bus into account. The corresponding limit will be defined by the field
bus.
The SmartWire-DT line may be extended up to 600 m.
1.4.1 Field bus connection
The field bus connection on the gateway uses RJ45 sockets. These sockets
are connected to each other by means of an integrated Ethernet switch. The
ETH2 and ETH2 ports feature diagnostic LEDs used to indicate the corre-
sponding link and data communications statuses. Finally, the unit will switch
from 10 to 100 Mbit/s and vice versa automatically.
Gateway Fieldbus
EU5C-SWD-EIP-MODTCP EtherNet/IP (default setting) or
Modbus TCP (selected via the web interface or with SWD-Assist)
Gateway Maximum number of modules at the SWD line
EU5C-SWD-EIP-MODTCP 99
Field bus-slave Max. input data [Byte] Max. output data [Byte]
EtherNet/IP 500 496
Modbus-TCP 800 642
￫
The sum of all input and output data must not exceed 1000
bytes.
￫
Information about the volume of input and output data of an
SWD module is provided in the Appendix of the manual "Smart-
Wire-DT Modules IP20", MN05006001Z or "SmartWire-DT Mod-
ules IP6x", MN120006.