33
Service and Maintenance
Transmission Oil Level Inspection Procedure
1. Park vehicle in a safe area on level ground.
2. Key off.
3. Set vehicle parking brake and chock wheels.
WARNING:
Apply vehicle parking brake and follow OEM parking instruc-
tions. Failure to follow these instructions could cause unintended vehicle
movement and may result in major vehicle component damage, property
damage, severe injury or death.
4. Locate the transmission check plug on the left side of the rear
housing.
5. Place a suitable container under the Oil Check Plug and remove the
check plug with a 6 mm hex key.
6. Oil level is correct when a small amount of oil runs out of the Oil Check
Plug hole.
Note:
If oil level is low, check for leaks (repair if necessary) and reference
Endurant HD Series Automated Transmission Service Manual
(TRSM0950)
, Oil Service Procedure, Fill Oil.
7. Inspect the Oil Check Plug and O-ring for damage. If damaged, replace
the Oil Check Plug; O-ring is serviced with plug.
8. Install the Oil Check Plug and torque to 24.5-29.5 Nm (18-22 lb-ft).
NOTICE:
Do not over-torque the Oil Check Plug or transmission damage
may occur.
!
