Eaton ATC-300+, Инструкция

Страница: 7 / 9

7
Initial Setup Screen
The initial setup screen allows the user to type in a name for the ATS controller. This
name will be displayed throughout the HMI status screens, and is for aesthetic
purposes only. The user can also disable the com link by pressing on the green circle.
Password Table Pop-up
Passwords are needed to get to the Engine Test and Go to Emergency (To S2)
screens. These two screens are at security level two which is factory set to
AC44 . If
you would like to change any of the passwords, navigate to the password table in the
SETUP screen (you must input
0300 which is the level 3 password). If you change it,
do not forget the level 3 password or you will be unable to edit passwords in the
future.
To enter the password table:
0300
To run an engine test: AC44
To transfer To S2: AC44