3
EATON
IB501001EN
Installation instructions
Installation Instructions - Arbor Bollard
Figure 3.
10. After base driver assembly is in position, add (1)
washer, (1) lock washer, and (1) nut per anchor bolt and
torque bolts to 30 ft.-lbs. (41 N-M). (Figure 3.)
Figure 4.
13. Lift fixture and slide it over base driver assembly and
align bottom holes with base extrusion. (Figure 4.)
ote:
N
Ensure the LED and ground wires do not get
pinched between base driver assembly and
fixture housing.
14. Use (3) 1/4” socket cap flat head screws and tighten to
30 in-lbs. (3.4 N-M) with Allen wrench.
11. Make wire connections, refer to wire diagram for power
connections. Connect the supply wires to appropriate
luminaire leads.
●
●
Supply side ground wire to green luminaire lead.
●
●
Supply side neutral wire to white luminaire lead.
●
●
Supply side line voltage wire to black luminaire lead.
12. Locate 2 pin polarized connector and ground wire on
driver assembly. Lift bottom open end of fixture and
position 2 pin connector and ground wire near top of
driver assembly. Assemble connector and connect
ground wires.
