Eaton 93PM-L 60-1, Инструкция по установке и эксплуатации, Страница: 88 / 164

76 Eaton 93PM-L 20 – 60 kW (208V) UPS Installation and Operation Manual P-164000711—Rev 03
6. Route the UPS building alarm and relay output interface wiring through the top interface entry conduit
landing plates to the UPS building alarm and relay output terminals. See
Figure 34 and Figure 35 for UPS
interface terminal locations.
7. Proceed to Step 13 .
8. Bottom Entry Wiring. Remove the bottom interface entry conduit landing plates to drill or punch holes
(see Figure 36 ).
9. Reinstall the interface entry plates and install the conduit.
10. Route the UPS building alarm and relay output interface wiring through the bottom interface entry conduit
landing plates to the bottom access interface wiring channel along the inside of the front door.
11. Route the wiring along the interface wiring channel.
12. Secure the wiring to the wire tie anchors provided (see Figure 37 ) using Zip ties.
13. Connect the building alarm interface wiring to the building alarm terminals. See paragraph
3.5 UPS System Interface Wiring Preparation and Table 21 for wiring and termination requirements, and
Figure 38 for terminal assignments.
14. Connect the relay output interface wiring to the relay output terminals. See Table 22 for wiring and
termination requirements, and Figure 39 for terminal assignments.
15. If wiring additional interface or control wiring options, see Table 20 for next option to install; otherwise,
proceed to Step 16 .
16. Close the UPS outside door and secure the latch.
UPS System Installation