Eaton 93E 30IAC-D, Инструкция по установке и эксплуатации

Страница: 44 / 76

Installation
4-10 Eaton 93E Integrated Accessory Cabinet-Distribution (30IAC-D and 60IAC-D) Installation and Operation Manual P-164000072—Rev 2 www.eaton.com/powerquality
10. If necessary, use a forklift or pallet jack between the supports on the bottom of the pallet to lift the pallet
by approximately 3 mm (1/8") and remove the skid (see Figure 4-6).
WARNING
Do not stand directly in front of or behind the pallet when unloading the cabinet. If unloading
instructions are not closely followed, the cabinet may cause serious injury.
11. Slowly roll the cabinet toward the rear of the pallet. Once the pallet tilts, continue rolling the cabinet down
the pallet extension plate until the cabinet is clear of the pallet.
12. Roll the IAC-D to the final installation location to the left of the UPS cabinet. Verify that the doors are flush
with each other.
13. If installing the cabinet permanently, retain the shipping brackets and hardware; otherwise, recycle the
pallet and shipping brackets in a responsible manner.
14. Secure the IAC-D in position by lowering the leveling feet until the cabinet is not resting on the inline
wheels and the cabinet is level.
WARNING
Failure to anchor the cabinet could lead to injury or death. To reduce this risk, the IAC-D, must be
secured to the building floor or to an adjacent 93E system cabinet.
15. If installing the cabinet permanently, continue to Step 16; otherwise, skip to Step 18.
16. Using the retained hardware (removed in Steps 4 and 5), reinstall the shipping brackets to the front and
rear of the IAC-D with the angle facing outward (see Figure 4-5 and Figure 4-6).
17. Secure the cabinet to the floor with customer-supplied hardware. Skip to Step 19.
18. Install cabinet bracket between the IAC-D and the adjacent UPS (see Figure 4-4).
19. Continue to paragraph 4.3.
NOTE 1 In Step 11 the pallet tilts and acts as a ramp once the cabinet is rolled beyond the
center of the pallet.
NOTE 2 The pallet extension plate may bend when the pallet is tilted, but will continue to
provide a smooth transition to the floor.
NOTE Use leveling feet only to level and lock the cabinet in place. Using the leveling feet to
raise the cabinet may result in serious injury to personnel or damage to the cabinet.