Eaton 93E 30IAC-D, Инструкция по установке и эксплуатации

Страница: 40 / 76

Installation
4-6 Eaton 93E Integrated Accessory Cabinet-Distribution (30IAC-D and 60IAC-D) Installation and Operation Manual P-164000072—Rev 2 www.eaton.com/powerquality
Figure 4-4. Cabinet Bracket
4.2.2 Unloading the 60IAC-D
To remove the pallet:
1. If not already completed, use a forklift or pallet jack to move the IAC-D to the installation area, or as close
as possible, before unloading from the pallet. Insert the forklift or pallet jack forks between the supports
on the bottom of the pallet (see Figure 3-6 for the IAC-D cabinet center of gravity measurements).
2. Open the front door by lifting the latch from the bottom and turning to the right (counterclockwise), then
swing the door open.
3. If the leveling feet are not fully retracted, turn all four leveling feet until they are retracted into the cabinet.
4. Remove four bolts securing the front shipping bracket to the cabinet and four bolts securing the bracket to
the pallet (see Figure 4-5). Remove the front shipping bracket. If installing the cabinet permanently, retain
the shipping bracket and securing hardware for later use.
5. Remove four bolts securing the rear shipping bracket to the cabinet and four bolts securing the bracket to
the pallet (see Figure 4-6). Remove the rear shipping bracket. If installing the cabinet permanently, retain
the shipping bracket and securing hardware for later use.
6. Close the door and secure the latch before rolling the cabinet from the pallet.
7. Remove three bolts securing the removable skid (see Figure 4-6).
8. Remove two bolts securing the pallet extension plate to the pallet and remove the plate (see Figure 4-5).
9. Install the pallet extension plate onto the rear of the pallet using the retained bolts (see Figure 4-7). Use
the mounting holes provided in the pallet (see Figure 4-6).
Cabinet Bracket