www.easy2access.net
Easy2Access A/S
®
EASY-908 Pin Code lock
31
Trouble
Cause
Solution
1
The lock cannot
be opened
properly after a
preset PIN code
is entered.
2
．
Low power
3
．
The clutch does not
working
4
．
Electronics damaged.
5
．
The spindle not installed
properly.
1
．
Change batteries
2
．
Check and repair the clutch
3
．
Replace the electronics part.
4
．
Re-install the spindle exactly to
the proper mark on it.
2
Handles are too
tight to be
turned.
2
．
The spindle does not
match
the
door
thickness.
3
．
There’s a declination for
the fixing holes.
1
．
Use a new lock whose spindle
matches the door thickness.
2
．
Adjust the location of the fixing
holes.
3
The outside or
inside lock unit
cannot be
armed or
disarmed
properly.
1
．
The
wireless
alarm
module in the lock not
working
2
．
The alarm unit is located
too closely to an electric
interference, i.e. PC, TV
set, big power motor, AC
power source, etc.
1
．
Replace the wireless module
2
．
Install the alarm unit a little far
away from the interference.
4
The inside
handle cannot
be locked.
1
．
Wrong inside PIN code
2
．
The inside spindle tube
not installed properly
1
．
Enter the right inside PIN code.
2
．
Adjust the spindle tube exactly
according to the mark on it.
5
The lock is
beeping
1. Low power
2. The
lock
is fully
functioning on the outside
3.
The
lock
is
not
functioning on the outside
1. Turn the key a ¼ until it is in
locked position.
2. The internal PCB is defect. Order
a new or call for service.
3. Call for service.
6
The lock cannot
lock
1. Is the key set to open
position. Then it will always
be open
2. Is the lock set to
permanent unlocking mode
1. Turn the key a ¼ until it goes into
a locked position.
2. Set lock in automatic locking
mode. Press: # 1 mastercode # 0
