www.easy2access.net
Easy2Access A/S
®
EASY-908 Pin Code lock
30
mortise after going outside,
enter the existing inside PIN code +
*. Don’t need to touch any other button
, just turn down the inside
handle to unlock in 10 seconds. After the timer expires, the inside
handle will get back to lock position, and when the Red LED on the lock
blinks once and one beep is heard, the wireless alarm arming demand
has been sent out. When one beep is heard and the red light turns on on
the alarm set, the alarm system has been armed successfully.
C.
Partial arming and you want to lock the three point mortise
after going outside,
enter the existing inside PIN code + * + * +
the POWER button
to put the inside handle in Unlock position for you
to go outside. In 3 seconds after the POWER button is pushed, the
outside handle will get into unlock position and will stay that for another
5 seconds. You have to lift up the outside handle to lock the three point
mortise before the timer expires. After the timer expires, the inside
handle and outside handle will get back to lock position simultaneously.
When the Red LED on the lock blinks twice and two beeps are heard, the
wireless alarm arming demand has been sent out. When two beeps are
heard from the alarm set and its red light turns on, the alarm system has
been armed successfully.
When you enter the inside PIN code + # (or *) again immediately after
entering the same sequence, the inside handle will get back to lock
position and the wireless alarm disarming demand will be sent out.
13.
Changing Batteries
When the power is lower than 3.3V, the lock will send out low-power alert.
You’ll hear 8 beeps and see the red LED blink.
When changing batteries be aware that for safety reasons the door will lock
on the inside, so be sure that when batteries are changed, a person around
you will know the pin code.
The PIN-codes in the lock will be remembered in the lock during change of
batteries.
14.
Trouble shooting
