www.easy2access.net
Easy2Access A/S
®
EASY-908 Pin Code lock
22
tube of the indoor unit.
5.
Gently finish joining the outdoor and
indoor units together, ensuring all fixing
posts are aligned properly. Make sure
the cables are not jammed by the door.
6.
Turn the handle to test the operation of
the latch.
7.
Remove the cover of the battery house
of the inside unit. Fasten the two
middle-length screws into the screw
holes inside the battery house and
through the two upper fixing posts.
8.
Fasten the longest screw into the screw
hole below the inside handle and
through the bottom fixing post.
9.
Insert 3 high-quality AA batteries -
this will enable you to program and test
the lock
10.Put the battery cover on and fasten
the screw.
C. Final inspection/adjustment prior to setup and use.
Note: After installation and prior to using the unit, make sure
you read and follow the steps below:
1.
Insert 3 new high-quality AA batteries in the battery housing.
2.
If the door lock beeps try to change to a new set of batteries as the
quality of batteries can be of differing quality and provide too low voltage
for the lock.
3.
Turn the handles down and up. They should turn freely. If and when the
inside and outside locks are attached securely. If the handles do not turn
