REMOTE OPERATION
26
Pre- / post-alarm record time
Select the pre-/post-alarm recording time from 0 sec. to 60 sec.
Record time setting
There are two ways to set the record time: Weekly and Custom.
Weekly
Click “Weekly” tab, and you will see a weekly time table indicating the week days (Mon ~ Sun) and hours
(0 ~ 24), similar to the figure below:
X axis:
0 ~ 24 hours. Each time interval within a square is 15 minutes.
Y axis:
Monday ~ Sunday.
Operation:
You can set the record schedule for 3 record types as needed in this time table:
1
st
timeline -- Schedule record, indicated in yellow,
2
nd
timeline -- Alarm record, indicated in magenta, and
3
rd
timeline -- Motion record, indicated in cyan.
Click and hold the start time point, and drag to the end time point to set the record time range.
Custom
Click “Custom” tab, and you can set a more specific record time range for the 3 record types: Schedule,
Motion, and Alarm.
How to add a new time setting:
i. Check the record type you want to schedule the recording.
ii. Set the start time (From) and end time (To).
iii. Click “Add” to add the time range you just set into the schedule table. Before adding the time range, you
will be prompted to confirm as follow:
iv. Check if the information shown is correct. Click “OK” if the information is correct. Click “Cancel” if the