OPERATING
6
TO TURN THE TOOL ON
Pull the trigger release button in with your thumb and then
squeeze the trigger with your fingers. (Once the tool is
running, you can release the trigger release button). To
turn the tool OFF, release the trigger.
WARNING:
To guard against injury, observe the following:
Read instruction manual before using,
Save instruction manual.
Keep hands away from chain.
Keep hands on handles. Don’t overreach.
A good, firm grip on the saw with both hands will help you
maintain control. Don’t let go. Grip the rear handle with your
right hand whether you are right or left handed. Wrap the
fingers of your left hand over and around the front handle,
and your left thumb under the front handle.
CHAIN
OILING
SYSTEM
(
Fig
2
)
Make sure you follow the instructions in maintenance for
putting oil in the chain saw.
CAUTION:
Failure to lubricate the chain will cause damage to
the bar and chain. Use only a goof quality bar and chain oil
or, if not available, unused SAE 30 weight motor oil may be
substituted.
NOTE:
It is normal for oil to seep from the saw when not in
use. To prevent seepage, empty the oil tank after each use.
When storing the unit for a long period of time (3 months or
longer) be sure the chain is lightly lubricated; this will prevent
rust on the chain and bar sprocket.
■ Use bar and chain lubricant (not provided) that is
formulated to perform over a wide temperature range with
no dilution required.
NOTE:
Do not use dirty, used or otherwise contaminated
oils. Damage may occur to the bar or chain.
■ Carefully pour the bar and chain oil into the tank.
■ Check and fill the oil tank when battery is recharged, or as
needed.
NOTE:
It is normal for lubricant to seep from the saw when
not in use. To prevent seepage, empty the oil tank after each
use. When storing the unit for a long period of time (three
months or longer) be sure the chain is lightly lubricated; this
will prevent rust on the chain and bar sprocket. Make
sure
oil
tank
lid
is
tightly
closed
.
TO INSTALL/REMOVE BATTERY PACK
This product will accept Earthwise 58 V lithium battery packs
only.
For complete charging instructions, refer to the Operator’s
Manuals for your battery pack and charger models.
WARNING: Always remove battery pack from your tool
when you are assembling parts, making adjustments,
cleaning, carrying, transporting or when not in use.
Removing battery pack will prevent accidental starting
that could cause serious personal injury.
NOTE:
To avoid serious personal injury, always remove the
battery pack and keep hands clear of the trigger release
button when carrying or transporting the tool.
To install battery pack:
■ Align grooves on battery pack with raised ribs in the tool’s
battery port and place the battery pack in the tool. (Fig 1)
WARNING: Make sure the latch on the tool snaps in
place and the battery pack is fully seated and secure in
the battery port before beginning operation. Failure to
securely seat the battery pack could cause the battery
pack to fall out, resulting in serious personal injury.
To remove battery pack:
■ Press the battery release button on the tool and
pull the battery pack out.
NOTE: Remove battery pack from unit. Fill oil tank with
bar and chain lubricant (not provided) before starting
the chain saw. Failure to lubricate the chain will cause
damage to the bar and chain.
(Fig 2)
Fig. 1
Fig
.
2
BATTERY RELEASE
BUTTON
