Coast wheel side
1” Cotter Pin
Drive wheel side
2” Cotter Pin
Step 1:
Remove the spreader and parts from the carton and arrange on the floor.
Step 2:
Install the bearing into the Lower Handles.
Note:
Notch on Bearings and slot in
the Lower Handles that the bearing fits into. Bearings must go through flat side
of Lower Handle (from the outside to the inside).
Slide Axle Bushing over Axle and into Axle Bearing to both sides as shown.
Step 3:
Install Drive Wheel onto the Axle
and align with the Cotter Pin
hole nearest to Lower Handles
as shown. Insert 2” Cotter Pin
through Wheel and through
Axle. Bend with pliers to prevent
pin from falling out.
Step 4:
Install Coast Wheel
onto the Axle fully, then using
outside Cotter Pin hole, insert 1”
Cotter Pin through Axle (not thru
the wheel). Bend with pliers to
prevent pin from falling out.
PAGE 2
ASSEMBLY
Axle
Bushing
Bearing
Drive wheel
Coast wheel
Bushing
Alignment
Notch
(Fits into the lower handle slot)
Axle Bearing
Flat
Side
Notch
TURN SPREADER UPRIGHT ON
TO THE WHEELS
to complete the next steps
