PAGE 3
ASSEMBLY
- continued
Step 5:
Now remove the Pivot Bracket from
the Lower Handles. Keep the 1/4
-20 x 2” bolts and locknuts for use in
reinstallation
Step 6:
Install Handle Shaft into Lower
Handles and then reattach the Pivot
Bracket assembly as shown onto the
Lower Handles using two 1/4 -20 x 2”
bolts and locknuts.
TIGHTEN BOLTS
AND NUTS NOW.
Step 7:
Remove one 1/4-20 Hex Nut from the Control Rod.
Next, push Lever forward to setting “0” to help align
the Control Rod with hole in Pivot Bracket, pull Lever
backward to insert Control Rod through hole in Pivot
Bracket. Now install 1/4-20 regular nut on to Control
Rod.
Step 8:
Insert the Pivot Rod into the Rod Clip that is installed
in the Pivot Bracket.
Note:
Make sure to ensure that
the Rod Clip is installed as shown to the right.
0
30
Control Rod
Tabbed Hole
Control Rod
Lever
Tension Nut
Gauge & Lever
30
¼
-20
Hex Nuts
Pivot
Bracket
Control
Rod
Pivot
Rod
Rod
Clip
Step 8:
Step 7:
