11
6.5 REMOVING THE CHARGER
Only for open batteries: Fill the cells with distilled water up to the level specified by the battery manufacturer. Close the battery cells using the
caps.
The device is maintenance-free if used according to its intended purpose.
Clean the terminal clips every time the charging procedure is completed. Remove all splashed battery acid from the pole callipers to prevent
corrosion. Clean the device carefully with a dry cloth. Do not use liquids or chemical cleaning agents. Never submerge the device in liquid. Never
allow liquids to flow over the device and to enter into the device.
Properly roll up the cable before storing the device to prevent damage to the cables and the device. Store the device in a dry and clean location.
In the positive cable of the eyelet adapter, there is a fuse holder, Figure 4. To replace
the fuse, open the cover and pull out the fuse. Replace the fuse with an equivalent
new one: Automobile flat fuse 10 A.
The internal fuse of the charger can only be replaced by a specialist workshop. Never
open the device yourself.
First pull the plug out of the socket and observe the sequence for disconnection. This prevents sparks from forming.
Since the charging of lead-acid batteries generates a highly-explosive gas, this is particularly important for the sake
of your safety.
Disconnect the charger from the mains power supply. Separate the adapter connection of the charging cable.
First disconnect the pole callipers from the battery, first minus then plus.
Allow the battery to cool down.
CAUTION
7. MAINTENANCE AND CARE
7.1 MAINTENANCE
7.2 CARE
7.3 REPLACING THE FUSE
8. NOTES REGARDING ENVIRONMENTAL PROTECTION
9. CONTACT INFORMATION
The packaging is made up of environmentally friendly materials which may be disposed of via your local recycling points.
Do not put electrical devices into the household waste! Electrical and electronic scrap must be collected separately and disposed of
in an environmentally responsible manner for recycling. Please contact your community or city administration regarding disposal
options for electronic scrap.
EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal
Germany
+49 (0)202 42 92 83 0
+49 (0) 202 42 92 83 – 160
[email protected]
www.eal-vertrieb.com
