4810 Clover Road • Greensboro, NC 27450 • 1-800-336-2776 • www.eagleequip.com • © Eagle Equipment 2017.12 • page 21
10. THE BALANCING OPERATION OF THE WHEEL CONT.
10.6 THE COUNTERWEIGHT HIDDEN-STICK MODE
Counterweight Hidden-Stick mode is only available in ALU-S mode, this mode can split this position
into two parts and make these two new positions hide behind the spoke, so you can achieve this hide
purpose. This balance mode is only available in ALU-S mode.
In 10.3 operation process, if outside counterweight is not hidden behind the spoke, but you still
want it hidden behind the spoke, you can follow below operation:
1. Press a+ key, back to figure 7-1 interface, press D key and OPT key, display input numbers
of spoke (Figure 10-13), press b+ or b- key, input spoke numbers, press D key and OPT key to
save and return, slowly turn the wheel, turn near imbalance position of spoke on the
top (12 o’clock), press D and OPT key to enter hide stick mode, and then press D and OPT key
to exit:
SPLIT MANUAL STICK OPERATION:
2. Stick inside operation is the same from section 10.3.3.
3. Slowly spin wheel, when outside counterweight position indicator lights (Figure 5-1(4)) are all on,
stick counterweight on at the 12 o’clock position outside of rim (Figure 10-18) right side.
4. Slowly spin wheel again, when outside counterweight position indicator lights (Figure 5-1(4)) are all
on, find second position, stick counterweight on at the 12 o’clock position outside of rim (Figure
10-9) right side.
SPLIT AUTOMATIC STICK OPERATION:
5. When stick inside, operation same 10.3.7 and 10.3.8
6. Slowly spin wheel, when outside counterweight position indicator lights (Figure 5-1(4)) are all on,
find first position, draught scale, when outside counterweight position indicator light(figure 10-11)
all on, turn scale, stick counterweight on rim (Figure 10-12).
7. Slowly spin wheel, when outside counterweight position indicator lights (Figure 5-1(4)) are all on,
find second position, draught scale, when outside counterweight position indicator light(figure 10-
11) all on, turn scale, stick counterweight on rim (Figure 10-12).
NOTE: When using the scale to stick the counterweight automatically, make sure the LED displays
“- - -”, if not, do not move the scale. Press the STOP and ALU key, then the middle LED display will
show “- - -”, now you can move the scale for automatically sticking the counterweight.
10.7 RECALCULATION
If you forget to input the rim data, you can enter it after the wheel balance test. At this time, you do
not need to press START. Instead, press the Recalculation Key (C). The sistem will follow the new rim
data calculation imbalance measure. Once the display shows the current imbalance value, press the C
key. You can also follow these steps to check the current rim data.
NR
3
Figure 10-13
