Product Manual SW108 and SW104
EAE KNX Switch Actuator
PM R2.0
©
EAE Technology
www.eaetechnology.com
Page 2 / 22
1
General
EAE KNX Switch Actuator has eight channels which can be configured with ETS3/ETS4 or higher
version. Each channel is independent of another. It has a separate bistable switching relay. SW108 /
SW104 has been designed especially for loads with high surge currents. It has 16A/20AX (C-Load)
relays inside channels. C-Load feature enables a convenient control of fluorescent lambs. Also device
has a manual operating feature. The relay can be switched on or off with slide switches.
The following function list provides;
•
Staircase
•
External logic
•
Internal logic
•
Priority
•
Threshold
•
Operating hour
•
Sweep
Each channel of devices can choose any of these functions. The outputs are parameterized
individually via ETS3/4. After bus voltage failure or voltage return the relay position is selected on
dependence on the parameterization. In “ETS reset”, device parameters are return download
configuration.
NOTE: Each channel is uniform. Device factory default physical address is 15.15.255.