E.ziclean vac100 by E.zicom
Manuel utilisateur – User Manual - Handleiding
E.ziclean vac100 by E.zicom
Manuel utilisateur – User Manual - Handleiding
First, open the dustproof clapboard and dump the dust and debris collected. (See Figure
1). Then clean it with cleaning brush (See Figure 2)
b. How to replace and clean the filter:
1. Hold the middle part of the filter bracket located on the suction inlet by hand (See figure
1) and thendraw horizontally (See figure 2).
2. Take out the scouring pad (See figure 3) and the filter sponge (See figure 3) in order.
3. Put a finger into the bottom of the suction outlet and draw it out (See figure 4).
4. Take out the filter sponge inside the outlet window (See figure 5).
5. The scouring pad and the filter sponge can be cleaned in water and then reinstalled
after drying. It’s recommend to generally clean them.
Installation:
1. Suction inlet: Install the filter sponge and the scouring pad onto the filter mesh bracket
orderly, and then install them into the dustbin.
2. Suction outlet: First install the filter sponge in the outlet window, and then insert the
top end of the outlet window into the dustbin, and then press the fastener at the lower end
to fix it.
c. Side brush:
01. Nip the tow fasteners of the side brush with one hand (see Figure 1) and pull the side
brush upward
with the other hand to take out the side brush.
02. Installation: Align the side brush with the 2 fasteners and press it down to fasten the
side brush (See Figure 2)
d. Main bush:
-
How to remove the main brush
01. Hold the brush and push it slightly leftward. (See Figure 1)
02. Then take out the brush. (See Figure 2)
