E.ziclean vac100 by E.zicom
Manuel utilisateur – User Manual - Handleiding
E.ziclean vac100 by E.zicom
Manuel utilisateur – User Manual - Handleiding
-How to clean center Brush
For a better cleaning effect, please regularly clean out the hair, yarn and large debris en-
winded or adhered on the main brush and the dust on the suction inlet .
01. Directly use the cleaning brush to clean paper scraps or minute particles.
02. En-winded hair, yarn or similar objects should be cut by scissors or pulled out by hand
while carefully rotating the main brush.
e. Cleaning Sensors
01. The sensors should be cleaned by cotton swab or soft cloth.
02. The wall-following sensors are installed in the front of bumper of the cleaner, the
ground detection sensors are installed at the front bottom of the cleaner (see the figure
below)
13. Trouble shooting
Below inspections by yourself to this product before you request a repair.
A. The Robot Stops while Working
01. Check if the selected cleaning time is over.
02. Check if there’s any error information on the LED display and refer to the following
explanations to solve it.
B. The Cleaner Fail to Work or the Cleaning Ability is Weakened
01. Check the battery status.
02. Check whether the dustbin, the filter and the inlet of suction are cleaned; whether the
side brush is working.
03. Check whether the cleaner is turned on.
C. The Remote Controller Can not Work
01. Check the battery status of the controller.
02. Check the battery status of the cleaner.
03. Wipe the IR sensor or the beam sensor of the controller by clean and dry cloth.
04. Keep proper distance between the cleaner and the controller, and then operate the
controller directlyfacing the IR receiver on the cover of robot
To ensure a more effective cleaning of this robot, please clean the sensors
regularly.
D. The Robot Fails to fulfill self-Charging
01. Check whether the power supply is normally connected with the adapter and charging
dock station.
02. Check the battery power, if it’s too low, please manually charge it with the adapter.
E. Increased Noise when Cleaning
01. Clean the dust box and the filter.
02. Check whether the brushes are too dirty.
