E.ziclean vac100 by E.zicom
Manuel utilisateur – User Manual - Handleiding
E.ziclean vac100 by E.zicom
Manuel utilisateur – User Manual - Handleiding
7. Functions of the buttons on the cover
1. In the standby status, press the mode button “
” to choose AUTO, SPOT, DOCKING
in turn,and corresponding indicator will be on accordingly .
2. AUTO: Auto cleaning status, in this status, press the select button “
” to switch
between 1, 2 and 3 secondary modes, the display will show corresponding digit.
Modes:
1
– The cleaner will work until the battery is used out and then search the charging
dock station automatically for recharge.
2
– The cleaning work will last for 30 minutes.
3
– The cleaning work will last for 15 minutes.
3. SPOT: Spot cleaning, in this status, press the selection button “
” to switch
between 1, 2 and 3 secondary modes, the display will show corresponding digit .
Modes:
1
– Cleaning along the spiral route (working for 1-4 minutes).
2
– Cleaning along the zigzag route (working for 1-4 minutes).
3
– Cleaning follow the walls (working for 10 minutes).
4. DOCKING: self-charging mode, in this mode, it can automatically search the charging
dock station.
5. Select button “
”: this enables you to select 1, 2, 3 secondary modes orderly in the
primary models of AUTO/SPOT.
6. UV button “
”: this allows you to turn on or off the UV lamp during the cleaning
process, press once to turn on and press again to turn off. (The UV lamp is on when turn
on the cleaner)
7. Run button “
”: when the SPOT/AUTO/DOCKING mode is selected, press this button
to start the particular mode.
8. Charging status
- When the cleaner is being charged manually, it will not work when you press any button
unless your pull out the plug of power adapter.
- A full charging time is about 3 hours. For the first 3 times of charging of a new cleaner,
please ensure it to be charged for more than 12 hours each time, please try to use out the
battery power before charging (ensure a 12-hour charging before you use the robot for the
first time).
- If you press the AUTO button on the remote controller while the cleaner is being charged
on thecharging dock station, the robot will draw back from the dock station and turn
around to walk 1m ahead, and then it will enter the AUTO mode for working.
9. How to use the charging dock station
1. Time setting :
In normal operation status, press the clock button “
” to enter the time setting status;
press once to switch between settings of minutes and hours, the current value of the
selected item being set will flash, by using this button, you can set the standard time.
Press the adjusting button “+” to adjust minutes, and hours. After time setting finished ,
then press the full-go button “
” to save the setting values. If no button were pressed
within 30 seconds, the base will quit the setting status without save the values.
2. Timing clean setting :
In normal operation status, press the timing button “
” to enter the timing clean setting
status; press once to switch between settings of minutes and hours, the current value of
the selected item being set will flash. By using this button, you can set the standard time.
Press the adjusting button “+” to adjuster minutes, and hours. After timing clean setting
finished. Then press the full-go button
“
” to save the setting values, if no button were pressed within 30 seconds, the base will
quit the setting status without save the values .
3. Auto clean setting :
In normal working status of the charging base, press the full-go button “
” to enable the
full-go function (when the battery is recharged fully, the robot will automatically start the
cleaning work). Press this button again, this function will be disabled.
