E-FLITE Habu 32 EDF ARF, Инструкция по эксплуатации

Страница: 42 / 108

42
EN

6. Measure back 1/2-inch (13mm) and 1
5
/
8
-inch (42mm) from where
the edge of the fan housing fits in the tube. Use these lines and those that
aligned with the fan fairing to draw a rectangle on the tube. Carefully draw
an airfoil shape that matches the fan fairing in the rectangle.
 7. Use hobby scissors to trim the exhaust tube for the fan fairing. Slot
the exhaust tube so it can be slid over the fan fairing.
 8. Repeat step 2 and 3 to reattach the fan fairing to the motor. Check
the fit of the exhaust tube on the fan unit. It may be necessary to trim the
opening slightly using hobby scissors.

9. Fit the fan housing into the fuselage. You may need to remove the
elevator servo horns and loosen the screws holding the pushrod supports
to fit the fan into the fuselage. Slide the fan forward to make sure it is fully
inserted into the intake.

10. Use a pin vise and 5/64-inch (2mm) drill bit to drill the four holes
for the fan mounting screws. Make sure to drill the holes against the tabs
of the housing so the fan does not slide forward or aft in the fuselage.
E-tips
You can also mount the pin vise in a drill so it can reach down inside the
fuselage saving some time when drilling the holes.