E-FLITE Habu 32 EDF ARF, Инструкция по эксплуатации

Страница: 33 / 108

33
EN

17. Slide a 3.5mm aluminum wheel spacer on the axle, then the
wheel with adapters. A 3.5mm wheel collar is used to secure the wheel
in position by tightening the setscrews onto the axle using a 1.5mm hex
wrench.

18. Check the operation of the nose gear retract using the radio
system. The nose gear door is precut to fit from the factory but some
minor sanding and trimming me be needed for final fit. Use a hobby knife
or rotary tool with a sanding drum for clearance.
E-tips
The end of the axles may have a slight bur on them from the factory. If
the wheel is hard to install, use a file to remove this bur.
rudder servo InstallatIon
Required Parts
Fuselage assembly Threaded rod, 2 1 /
4
-inch (57mm)
Metal clevis (2) 2mm nut (2)
Silicone tubing Servo with hardware (JR368)
18-inch (457mm) servo extension
Required Tools and Adhesives
String Pliers
Threadlock Phillips screwdriver: #1
Side cutters Scissors
Clear tape Thin CA
 1. Secure an 18-inch (457mm) servo extension to the rudder servo
using string or a commercially available connector.

2. Center the rudder servo using the radio system. Use side cutters to
remove any arms from the horn that may interfere with the operation of
the servo.
E-tips
The rudder linkage will be connected to the hole in the servo horn 1/2-
inch (13mm) from the center of the arm as illustrated in the photo above.
 4. Remove the cover from the fuselage for the rudder servo. Set the
cover aside until needed later in this section of the manual.