E-FLITE Habu 32 EDF ARF, Инструкция по эксплуатации

Страница: 36 / 108

36
EN

3. Remove the spar from the fuselage using a 2.5mm hex wrench.
Check the fit of the spar in the stabilizer. It should easily slide in up to the
line drawn on the spar in the previous step.
 4. Check the fit of the stabilizer on the fuselage. It must fit tightly
against the fuselage when the screws are installed that secure the spar
to the fuselage. If the spar fits into the stabilizer and fuselage without any
problems, the fit of the stabilizer to the fuselage should be perfect.

5. Repeat steps 1 through 4 to check the fit of the remaining stabilizer
to the fuselage. Both stabilizers should be positioned on the fuselage at
this time.

6. Attach the wing panels to the fuselage using a 9/64-inch hex
wrench. Stand back 8–10 feet (2–3 meters) and check that the stabilizers
are positioned an equal distance from the wing. If not, the spars may need
to be sanded slightly to correct any alignment issues.
Equal distance
 7. Remove the spar from the fuselage and stabilizer. Use medium
grit sandpaper to lightly sand the spar where it will fit into the stabilizer.
Sand both the front and back of the spar.

8. Apply a thin coat of petroleum jelly to the fuselage around the
spar socket. This will keep you from accidentally gluing the stabilizer to
the fuselage during the following procedure.
E-tips
Before mixing any epoxy, make sure to read through and understand the
following steps. It is important to perform these steps before the epoxy
fully cures.