E-FLITE Habu 32 EDF ARF, Инструкция по эксплуатации

Страница: 19 / 108

19
EN

6. Place 2–3 drops of thin CA in each of the holes. This will harden
the threads made by the screws making them more secure when the
landing gear block is installed.
E-tips
Always use threadlock on metal-to-metal fasteners to prevent them from
vibrating loose.
 7. Slide a main gear strut into the main landing gear block. Use the
setscrews and a 1.5mm hex wrench to secure the main gear wire in the
block. The setscrews will tighten down on each side of the flat at the top
of the strut to prevent the strut from rotating in the block. Assemble the
right and left main gear assemblies at this time.

8. Place the correct main gear assembly in position. The axle will face
to the root of the wing, and the spring will face to the trailing edge of the
wing. Use four 3mm x 14mm countersunk self-tapping screws and a #1
Phillips screwdriver to tighten the screws.

9. With the flap lowered, rest a square against the flap hinge line.
Look down on the axle and check that it is perpendicular to the square
as shown. If not, it may be necessary to lightly file the flat areas on the
landing gear wire to correct for any misalignment.
 10. Select the correct adapter that fits to the landing gear strut.
Insert two adapters in either side of the hub of the wheel.
 11. Use a flat file to make a 1/4-inch (6mm) wide flat area on the
gear near the end of the axle strut for the setscrew to rest. This will keep
the wheel collar from vibrating loose in flight.