6
EN
Binding is the process of programming the receiver of the control unit to recognize the GUID (Globally
Unique Identifier) code of a single specific transmitter. You need to ‘bind’ your chosen Spektrum DSM2
technology equipped aircraft transmitter to the receiver for proper operation.
Note
: Any JR
®
or Spektrum DSM2 aircraft transmitter can bind to the Spektrum AR6400L receiver. Due to the
aerobatic capabilities of the UMX Extra 300 3D, we recommend using a transmitter with adjustable exponential
and dual rates. Please visit www.bindnfly.com for a complete list of compatible transmitters.
Transmitter and Receiver Binding
Note:
When using a Futaba transmitter with a Spektrum DSM2 module, you will need to reverse the throttle channel.
Binding Procedure
1. Refer to your transmitter’s unique instructions for binding to a receiver.
2. Make sure the flight battery is disconnected from the aircraft.
3. Power off your transmitter.
4. Connect the flight battery in the aircraft. The receiver LED will begin to flash rapidly (typically after 5
seconds).
5. Make sure transmitter controls are neutral and throttle and throttle trim are in low position.
6. Put your transmitter into bind mode. Refer to your transmitter’s manual for binding button or switch
instructions.
7. After 5 to 10 seconds, the receiver status LED will become solid, indicating the receiver is bound to
the transmitter.
Note
: If the LED does not go to a solid light, refer to Troubleshooting Guide at back of manual.
Note
: Always disconnect the Li-Po from the receiver of the aircraft when not flying. Failure to do so will
render the battery unusable.
Before Flight
First Flight Preparation
1
Lower throttle and throttle trim
to lowest settings.
2
3
Continuous LED
Power on
transmitter
Wait 5
seconds
Connect Flight Battery and attach
to hook and loop strip.
CAUTION
: When armed, the motor will turn the propeller in response to any throttle movement.
When the aircraft does not respond, binding may be required.
1
Lower throttle and throttle trim
to lowest settings.
2
3
Continuous LED
Power on
transmitter
Wait 5
seconds
Connect Flight Battery and attach
to hook and loop strip.
• Remove and inspect contents
• Read this instruction manual thoroughly
• Bind aircraft to your transmitter
• Install the flight battery in the aircraft
(once it has been fully charged)
• Make sure carbon fiber control rods move freely
• Make sure flight control surfaces are centered
• Perform the Control Direction Test with the
transmitter
• Adjust flight controls and transmitter
• Adjust battery for center of gravity (CG)
• Perform a radio system Range Check
• Find a safe and open area
• Plan flight for flying conditions
Modellbau Lindinger GmbH e-Mail: [email protected] www.lindinger.at
Modellbau Lindinger GmbH e-Mail: [email protected] www.lindinger.at
