17
E-flite Extra 300 32e ARF Assembly Manual
11. Slide the stabilizer tubes in the stabilizer. Use
an epoxy brush to apply a thin layer of epoxy on
the root end of the stabilizer.
12. Use an epoxy brush to apply a thin layer of
epoxy on the exposed wood of the fuselage at this
time as well.
13. Slide the stabilizer into position. It must be
pressed tight against the fuselage. Use a paper towel
and rubbing alcohol to remove any excess epoxy.
14. Apply a small amount of epoxy in the holes
of the stabilizer for the stabilizer tubes in the
remaining stabilizer half.
15. Use an epoxy brush to apply a thin layer of
epoxy on the root end of the stabilizer. Also apply
epoxy to the exposed wood on the side of the
fuselage as described in Step 12.
16. Slide the remaining stabilizer into position. It
must be pressed tight against the fuselage. Use a
paper towel and rubbing alcohol to remove any
excess epoxy. Set the fuselage assembly aside until
the epoxy has fully cured.
