EN
Model Assembly
Continued
Rudder Installation
Continued
7. Attach the Z-bend (
E
) of the control linkage to the servo arm’s outermost
hole, with the Z-bend facing in as shown.
8. Ensure the rudder servo arm is in the correct position and the rudder is
centered, then snap the ball link (
F
) onto the ball of the rudder control
horn (
G
). Ensure that the rudder is centered; remove and adjust the ball
link if necessary.
When needed, disassemble in reverse order.
Horizontal Stabilizer Installation
1. Slide the horizontal stabilizer tube (
A
) into the hole in the rear of the
fuselage.
2. Install the 2 piece (left and right) horizontal stabilizer as shown. Ensure
the control horn faces down.
3. Secure the 2 piece tail in place with 2 screws (
B
) in the bottom of each
side of the horizontal tail.
G
E
F
A
B
15mm (2)
6
