EN
Model Assembly
Continued
Motor and Propeller Installation
1. Install the collet (
A
), drive washer (
B
) and spinner backplate (
C
) on the
motor shaft (
D
).
2. Install the propeller (
E
) propeller washer (
F
), and propeller nut (
G
) on the
prop shaft.
3. Align the propeller with the two pins (
H
) on the propeller back plate as
shown. Tighten the nut and ensure it secures the propeller snugly against
the pins.
4. Install the spinner cone (
I
) over the propeller and spinner backplate. Secure
the spinner cone in place with the 2 included screws (
J
).
IMPORTANT:
Only tighten by hand, tighten one screw until it just starts to
snug then tighten the other screw to the same distance. Follow this alternating
process until the spinner cone is fully snug to ensure an even placement.
IMPORTANT:
The propeller size numbers (
15 x 5.5
) must face out from the
motor for correct propeller operation. Ensure the nut holds the propeller tightly
without damaging the propeller.
Disassemble in reverse order. Not all wiring shown.
NOTICE:
If the propeller is not balanced, the aircraft may vibrate, causing the
stabilization system to not operate correctly and/or decrease the life of the
servos.
Horizon Hobby does not warrant replacement if the servos are used under
extreme vibration or the stabilization system is used with an unbalanced
propeller.
For more information, view our propeller balancing video on Horizon Hobby’s
Youtube channel https://www.youtube.com/watch?v=OXuNnYQO2s4
NOTICE:
Remove the propeller before radio system setup or accidental
injury may occur.
A
B
C
D
E
G
J
I
H
F
11
