DYNISCO SC170 Manual
16
16
16
16
16
16
16
16
16
16
and the leftmost digit position will start blinking (shown here in italics)
asking if the tens position needs to be changed. To change the
thousands position, start pressing the NEXT key and the
leftmost digit will increment through 1 2 3 4 5 6 7 8 9 0. Stop
pressing the NEXT key at any of the numerals desired, then
press ENTER to accept the selection. If the numeral selected
before pressing ENTER was 0, then the display would change to
and the second digit from the left will start blinking (shown here in
italics) asking if the hundreds position needs to be changed. As
before, to change the number in this digit position repeatedly press
the NEXT key until the desired numeral is reached. Then press
ENTER to go to the next lower significant digit position. Each
time the NEXT key cycles through the ten choices for that digit
position and the ENTER key enters the selected number. The
digit position being changed is the one that is blinking. The legend on
the display will change successively to
After the hundreth’s digit position has also been changed to the desired
value, the next pressing of the ENTER key returns the transmitter
to the alternating display of CHANGE ZERO. Since changing of
the zero has just been completed, press the NEXT key to
proceed to the next menu selection, CHANGE FULL SCALE.
NEXT
ENTER
NEXT
ENTER
NEXT
ENTER
NEXT
ENTER
4
000.00
TENS ?
4
00.00
ONES ?
0
4
0.00
TENS ?
00
4
.00
ONES ?
000.
40
TENTHS ?
00.0
40
HUNDTH ?
ENTER
CHANGE ZERO.
NEXT
CHANGE FULL SCALE.