Dynascan DB-59, Инструкция по эксплуатации

Страница: 36 / 39

English - 16 -
17.- DCS TABLE:
18.- TROUBLESHOOTING:
If you have problems with the transceiver, follow the procedures in the following table and
if the problems persist reset the transceiver or contact the Technical Service.
PROBLEM SOLUTION
The transceiver cannot be
powered ON. The battery may be exhausted, please change the new
battery or re-charge it.
The battery was not installed correctly, please reinstall it.
The battery charge is too
short to use. The battery life is over, please change a new battery.
The battery is not fully charged.
The receiving LED
flashing, but nothing is
heard from the speaker.
Make sure that the volume is set correctly.
Make sure that the CTCSS/DCS settings are the same as
the other transceivers in your user group.
Make sure that the mute mode is correct.
The keypad does not work. Make sure that the key lock function is not enabled.
Make sure that the any key is not pressed.
In standby mode, the
transceiver will transmit
automatically
even the
[PTT] is not pressed.
Make sure if the VOX function is enabled or disabled and
its level is set too low or not.
Some functions cannot be
stored normally. Verify if the transceiver is working in channel mode, since
some functions are only set in channel mode via
programming software.
Interference signals or
other communications are
received from other user
groups.
Change the CTCSS/DCS codes of all the transceivers in
your user group.