10
Long-Term Care Bed • D500 • 5 Function Ultra Low Bed (Reorder No. 12005)
Long-Term Care Bed • D500 • 5 Function Ultra Low Bed (Reorder No. 12005)
11
EQUIPMENT OPERATION
1. POSITIONING THE BED
To position the bed unlock the casters. Once the bed
is in its desired location, lock all casters in place.
2. USING THE HAND PENDANT
The UP arrow (▲) indicates raising the corresponding
parts of the bed.
The DOWN arrow (▼) indicates lowering the corre-
sponding parts of the bed.
Use button 1 and 2 to
adjust the backrest up or
down.
Use button 3 and 4 to
adjust the kneebreak up
or down.
Use button 5 and 6 to
adjust the backrest and
kneebreak up or down
simultaneously. (Auto
Contour feature)
Use button 7 and 8 to
raise or lower the bed
platform.
Use button 9 and 10
to tilt the bed into re-
versed Trendelengburg
and Trendelenburg posi-
tions.
2.1 ENTRAPMENT SAFETY MEASURE
The bed is equipped with an Entrapment Safety
Measure. If the bed platform is higher than 12.5" from
the fl oor, long press button 8 will lower the bed to
12.5". To continue lowering the bed, release and long
press button 8 again. Ensure no body parts or
obstacles are within the bed’s moving range. Ensure
the bed rails/bars are raised.
2.2 RESETTING THE BED
Where a connection fault is identifi ed and rectifi ed,
the control system will require a reset in order to
operate again. If the fault occurred on the motors for
platform profi ling, lower the corresponding motor to
the lowest position for reset; where the fault occurred
on the motors for bed height adjustments, raise the
bed to the highest position for reset.
EQUIPMENT OPERATION
(Continued)
3. ADJUSTING THE EXTENDED
HEEL LIFT
The end foot section can be adjusted manually to
further alter the kneebreak angle.
1. Grip the end section of the bed platform. Lift up
slowly to the preferred height. Ensure there is an
audible click indicating that the deck is locked in
place within the Ratcheting Bracket.
2. To lower the end deck to its original position, lift
up to the highest position and slowly lay the bed
platform back down.
4. FOLDING AND TRANSPORTING
THE BED
The bed can be disassembled and transferred in a
compact manner using the transport bars.
1. Reverse the bed installation procedure to disas-
semble the bed into four sections, the headboard,
the footboard, the upper and lower bed decks.
Keep the screws and washers.
2. Position the transport bar with the deck connection
brackets facing upwards. Insert a transport bar on
each of the headboard connection brackets.
3. Insert the footboard into the other side of the
transport bar.
4. The folded bed can be transported with the
casters on the head and footboard. Reverse the
procedure to reassemble the bed.
