Dynapac PL 500/20 S, Руководство по эксплуатации и техническому обслуживанию

Страница: 198 / 234

F 38
F PL
500/
20S.
G
B 38
-74
- 04.
07
Side boards
Sliding shoes
The side boards which slide over the
ground (1) should be checked every 50
hours to ensure that they are still proper-
ly attached.
There is one side board on either side of
the milling box.
The sliding shoes on the side boards are
in continuous sliding contact with the as-
phalt during milling operations, as a re-
s u l t o f w h i c h t h e y a r e s u b j e c t t o
increased levels of wear. Once the ma-
terial on these shoes becomes too thin,
the shoes have to be replaced.
Check the sliding shoes on both side
boards at regular intervals and replace if
required.
- Remove side board (1) A:
- Lower side board until it makes con-
tact with the ground.
- Unscrew stop plate (2).
- Disconnect the cable sensor (3) if fit-
ted.
- Remove the cables (4) used for rais-
ing and lowering the side board.
Eye bolts can be employed instead of
cables for restraining and raising the
side board after removal.
- Remove guide bolts (5).
- Cut the welded sliding shoes (6) off
the side board.
- Weld new sliding shoes firmly to the
side board.
Take all necessary safety precautions
during cutting and welding work!
Iso500_compl_short.wmf,Box1_PL500_V2.wmf,Seitenschild1_PL500_V2.wmf
5
3
4
1
6
2